Telkom-3 Launch Failure and Telkom 3S at 118°E

Telkom 3S Tuning satellite tuning card. Telkom 3S (118°E). Frequency 12560 MHz, polarity H, symbol rate 10000 kS/s.

Telkom-3 reached an unusable orbit after its 2012 launch. The 118°E tuning reference on this page is for Telkom 3S, launched in 2017.

Satellite tuning settings

SatelliteFrequency (MHz)PolaritySymbol rate (kS/s)FECSystemAccess or package
Telkom 3S (118°E)12560H100003/5DVB-S2 / 8PSKTransvision

Sources and current listings — Telkom Indonesia · LyngSat

How to check the current listing

The table for Telkom-3 Launch Failure and Telkom 3S at 118°E includes Telkom 3S (118°E) at 12560 MHz, polarity H, with symbol rate 10000. Read the satellite and access notes alongside that row before entering the settings. The numbers describe one listed carrier and may be shared by several services.

Search your current guide using the name or successor mentioned above and check its satellite and provider. A replacement service can use a different transponder, a different satellite or a different distribution method. If the original name still appears after a scan, inspect the service information and compare it with an updated guide before deleting saved entries.

Checking the receiver result

A signal strength reading can indicate that the receiver sees power or energy at its input. Signal quality is the more useful reading for confirming that it can lock to the selected carrier. If quality stays at zero, check the satellite selection, the LNB settings and the switch port. If several known active carriers also fail, inspect alignment and cabling before changing individual channel entries.

After the receiver locks, run a manual transponder scan and review the results by service name. Check the scan filter if the expected service is missing. A free-to-air-only filter can exclude encrypted services from the results. Save a working channel only after confirming that it matches the intended service, especially if the receiver already holds several similarly named entries.

Frequently asked questions

Can I use an older listing to find Telkom-3 Launch Failure and Telkom 3S at 118°E?

Use older information to identify the service, then compare the name and distribution details with a current source. A historical listing may no longer match an active transmission.

Why does a scan show signal but no picture?

Check whether the receiver actually has signal quality and carrier lock. If it does, verify that the service is still in the scanned package and that the receiver supports its video format and access requirements.

Will the same settings work in every location?

Reception depends on the satellite beam and the dish setup at your location. Compare the listed beam with your region, and use a known active transponder on the same satellite to check reception.

Read Telkom-3 and Telkom 3S as separate spacecraft

Telkom-3 did not reach its intended orbit after the 2012 launch failure. Telkom 3S is a separate spacecraft listed at 118°E. A receiver profile may use a shortened Telkom label, so compare the orbital position and transponder with the 3S reference before scanning.

Frequently asked question

Can I tune Telkom-3 from the historical launch entry?

Use a checked Telkom 3S listing for the relevant 118°E service. The failed launch entry is historical context.