DTHsat Updated 13-11-2026
CIS TV HD TV Frequency on Hotbird 13E Satellite KU band LNB TV Channels
CIS TV Channel TV Frequency TP
CIS TV Satellite Hotbire 13 E same TP TV Channels Frequency List
CIS TV Frequency on Hotbird Satellite 13.0° East TV channels list frequency Updated 13-11-2026 LNB Type KU Band
Channel Name |
Frequency |
Polarity |
Symbol Rate |
Freq |
CIS TV |
11054 |
H |
27500 |
5/6 |
CIS TV Frequency on Hotbird Satellite 13.0° East TV channels list frequency Updated 13-11-2026 LNB Type KU Band
CIS TV Frequency on Hotbird Satellite 13.0° East TV channels list frequency Updated 13-11-2026 LNB Type KU Band
Hotbird Satellite Hotbird 13E Strong TP Frequency for Dish antenna settings TV Channels frequencies List LNB Type KU band
Galaxy-19 Satellite 97.0° West Strong TP Frequency for Dish antenna settings Channel frequencies List LNB Type C and KU band
The table for CIS TV Channel includes CIS TV at 11054 MHz, polarity H, with symbol rate 27500. Read the satellite and access notes alongside that row before entering the settings. The numbers describe one listed carrier and may be shared by several services.
When a receiver shows several versions of the same name, compare the satellite, provider and service information on each result. Standard-definition, HD and regional feeds may be separate services. Keep the existing entry until you have confirmed which version is available, and use the access note to determine whether a subscription is required.
A signal strength reading can indicate that the receiver sees power or energy at its input. Signal quality is the more useful reading for confirming that it can lock to the selected carrier. If quality stays at zero, check the satellite selection, the LNB settings and the switch port. If several known active carriers also fail, inspect alignment and cabling before changing individual channel entries.
After the receiver locks, run a manual transponder scan and review the results by service name. Check the scan filter if the expected service is missing. A free-to-air-only filter can exclude encrypted services from the results. Save a working channel only after confirming that it matches the intended service, especially if the receiver already holds several similarly named entries.
Start with the relevant row in the table. Match the frequency, polarity and symbol rate together and check that your receiver is on the satellite named with the entry.
Check whether the receiver actually has signal quality and carrier lock. If it does, verify that the service is still in the scanned package and that the receiver supports its video format and access requirements.
Reception depends on the satellite beam and the dish setup at your location. Compare the listed beam with your region, and use a known active transponder on the same satellite to check reception.